ePort Parts and Products

This cable extends the current Card Reader serial cable by and additional 10 feet. This may be required when the ePort Telemeter is not located wit...

This cable extends the DEX Cable another ten feet whenever the DEX Port is too far away to support the standard six foot DEX Cable. This cable does...

The Antenna Extension Assembly Kit allows the installation of the High Gain Antenna for G8, G9, and EDGE (8' cable and 4' cable versions) on machin...

The High Gain Antenna was designed to help optimize signal for the ePort G8, G9 and EDGE in areas with low signal strength. It requires a 7/16" hol...

The High Gain Antenna was designed to help optimize signal for the ePort G8, G9 and EDGE in areas with low signal strength. It requires a 7/16" hol...

This interface kit will work with the ePorts G9, G10, and G11.  This interface kit is required for Coin Pulse installation to ease the installation...

This kit will replace the existing front cover when installing an ePort System when you need a second knockout. The current front cover is preventi...

This is a 10' MDB extension cable for use with any ePort device.  This cable is used in machines when the ePort device must be mounted in a positio...

This is a 3' MDB cable for use with any ePort device. It is used to connect ePorts to the Multi Drop Bus (MDB) of the vending equipment. For use wh...

This is a 6' MDB cable for use with any ePort device. It is used to connect ePorts to the Multi Drop Bus (MDB) of the vending equipment. For use wh...

The ePort G9, G10 and G11 is designed to receive power from the MDB cable harness. When power is not available this way, this power supply will pro...

This security plate replaces the point-of-sale (POS) window to provide a mounting surface for the ePort card reader. A spacer is required with use ...

This item supports connecting the Vendi card reader which a 10 pin Molex connector, to the serial RS232, 9 pin D connector, of PC computer.  Part #...

This item supports connecting the Vendi or Vivotech card reader which a 10 pin Molex connector that connects to an ePort Telemeter which has a six ...

This connector cable is necessary to connect the MEI 3-in-1 and 4-in-1 Combo Bezels to the ePort G8, G9, and G10 Step Down Power Supply to connect ...

This spacer (part #V6SUF1435002) will extend the IDTech Vendi Card Reader (part #V9SUK1235003)  another 1/2" away from the machine wherever the car...

Protective waterproof splash cover for all ePorts.  Four new screws (3/16 inches longer) will be required to reinstall the ePort. Online Installati...

This serial cable is necessary to provide the interface when using a Coinco or MEI Combi Bezel with the G8 and G9 Controller as the Telemeter. The ...