ePort Parts and Products

This cable extends the current Card Reader serial cable by and additional 10 feet. This may be required when the Telemeter is not located within si...

This cable extends the DEX Cable another ten feet whenever the DEX Port is too far away to support the standard six foot DEX Cable. This cable does...

The Antenna Extension Assembly Kit allows the installation of the High Gain Antenna for G8, G9, and EDGE (8' cable and 4' cable versions) on machin...

The High Gain Antenna was designed to help optimize signal for the G8, G9 and EDGE in areas with low signal strength. It requires a 7/16" hole for ...

The High Gain Antenna was designed to help optimize signal for the G8, G9 and EDGE in areas with low signal strength. It requires a 7/16" hole for ...

This is a 10' MDB extension cable for use with any credit card reading device.  This cable is used in machines when the device must be mounted in a...

This is a 3' MDB cable for use with any credit card reader device. It is used to connect to the Multi Drop Bus (MDB) of the vending equipment. For ...

This is a 6' MDB cable for use with any credit card reader device. It is used to connect to the Multi Drop Bus (MDB) of the vending equipment. For ...

This security plate replaces the point-of-sale (POS) window to provide a mounting surface for the credit card reader. A spacer is required with use...

This item supports connecting the Vendi card reader which a 10 pin Molex connector, to the serial RS232, 9 pin D connector, of PC computer.  Cantal...

This item supports connecting the Vendi or Vivotech card reader which a 10 pin Molex connector that connects to a Telemeter which has a six pin Mol...

This connector cable is necessary to connect the MEI 3-in-1 and 4-in-1 Combo Bezels to the G8, G9, and G10 Step Down Power Supply to connect to the...

Protective waterproof splash cover for all credit card reader systems.  Four new screws (3/16 inches longer) will be required to reinstall the cred...

This serial cable is necessary to provide the interface when using a Coinco or MEI Combi Bezel with the G8 and G9 Controller as the Telemeter. The ...